Rear

a Air Vents

b USB Connector

Connect a Hi-Speed USB 2.0 compatible USB cable here.

c DIP Switches

Configure these switches to specify the SCSI ID or terminator ON or OFF.

d SCSI Connectors

Connect a SCSI cable (50-pin half pitch, pin type) here.

e Power Cord Connector

Connect the provided power cord here.

CAUTION

•Never touch the cables at the rear of the scanner. Disconnection of these cables can cause a malfunction of the scanner.

•Take care to ensure that the vents never become blocked. Blocked vents can lead to heat build-up inside of the scanner and create the risk of fire.

■Setting the SCSI ID and terminator

Set the SCSI ID and terminator using the DIP switches located between the SCSI connectors and power cord connector.

For details on the settings, refer to the User Manual.

SCSI ID

 

 

 

 

Terminator

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1 2 3 4

SCSI ID

SW1

SW2

SW3

0

OFF

OFF

OFF

1

ON

OFF

OFF

2

OFF

ON

OFF

3

ON

ON

OFF

4

OFF

OFF

ON

5

ON

OFF

ON

6

OFF

ON

ON

7

ON

ON

ON

Refer to the table when setting the SCSI ID. If other SCSI devices are connected to or built into the computer, make sure that none of the SCSI IDs overlap.

IMPORTANT

•The SCSI ID is factory set to 2.

•You can set the SCSI ID between 0 and 7. However, do not use ID 7 as this ID is usually assigned to the SCSI controller. In addition, when the SCSI hard disk drive is built in, do not use IDs 0 and 1 as these IDs are usually assigned to the hard disk.

12