30Recording

IMPORTANT

Observe the following precautions while the

card access display ( ) appears on screen and when the CARD access indicator is on or flashing. Failing to do so may result in permanent data loss.

-Do not open the memory card slot cover and do not remove the memory card.

-Do not disconnect the power source or turn off the camcorder.

-Do not change the position of the / switch or the operating mode.

NOTES

If the subject is not suitable for autofocus, turns yellow. Adjust the focus manually ( 53).

When the subject is too bright, “OVEREXP.” starts flashing. In such case, use the optional FS-43U II ND filter.

Zooming

POINTS TO CHE K

( 12)

: In addition to the 10x optical zoom, the 200x digital zoom is also available ( 39).

Zoom out

Zoom in

10x Optical Zoom

Move the zoom lever toward W to zoom out (wide-angle). Move it toward

Tto zoom in (telephoto).

You can also change the zoom speed

( 39). You can select one of three fixed zoom speeds or a variable speed that depends on how you operate the zoom lever: Press gently for a slow zoom; press harder for faster zooms.

NOTES

You can also use the T and W buttons on the wireless controller or the LCD panel. The zoom speed with these buttons will be the same as with the camcorder (when one of the fixed zoom speed levels is selected) or fixed at

[ SPEED 3] (when [ VARIABLE] is selected).

When set to [ VARIABLE], the zoom speed will be faster in the record pause mode. Keep at least 1 m (3.3 ft.) away from the

subject. At wide-angle, you can focus on a subject as close as 1 cm (0.39 in.).