Message | Action | |
“The following ink tank cannot be | z The ink tank is not installed. Install the ink tank. | |
recognized.” | See “Replacing an Ink Tank” on page 46. | |
U043 | ||
z The ink tank is not compatible with this machine. (The lamp on the ink tank is | ||
U140 | ||
off.) | ||
U150 | Install an appropriate ink tank. | |
| See “Replacing an Ink Tank” on page 46. | |
| z An ink tank error has occurred. (The lamp on the ink tank is off.) | |
| Replace the ink tank. | |
| See “Replacing an Ink Tank” on page 46. | |
“**** | Turn off the machine, and unplug the power cord of the machine from the power | |
Printer error has occurred. | supply. After a while, plug the power cord of the machine back in, and then turn | |
Turn off power then back on again. If | on the machine. If the same error occurs, contact a Canon service | |
problem persists, see the manual.” | representative. | |
“Scanner is not operating correctly.” | Turn off the machine, and unplug the power cord of the machine from the power | |
| supply. After a while, plug the power cord of the machine back in, and then turn | |
| on the machine. If the same error occurs, contact a Canon service | |
| representative. | |
“The card is currently | The Card Slot is set to Read/write mode. | |
Set to | You cannot print in this mode. After writing on the memory card, set to Read- | |
performing operation.” | only mode again. | |
“An unsupported USB hub is | If a PictBridge compliant device is connected via a USB hub, remove the hub | |
connected. | and connect it directly to the machine. | |
Remove the hub.” |
| |
LCD Cannot Be Seen At All | ||
|
| |
Cause | Action |
The machine is not powered on or the LCD is in the
zIf the Power lamp is off
The machine is not powered on. Connect the power cord and press the ON/ OFF button. The machine will power on and the LCD will display a message.
zIf the Power lamp is lit
The LCD may be in the
An Unintended Language Is Displayed on the LCD
Cause |
| Action |
|
The language you want to be displayed | Select the language you want to be displayed according to the following | ||
is not selected. | procedure. |
|
|
| (1)Press the HOME button. Wait for about 5 seconds, select | , and then | |
| press the OK button. |
|
|
| (2)Press the ] button to select | , then press the OK button. | |
| (3)Press the } button four times, then press the OK button. |
| |
| If the Bluetooth unit is connected to the machine, press the } button five | ||
| times, and then press the OK button. |
| |
| (4)Use the { or } button to select the language you want to be displayed, then | ||
| press the OK button. |
|
|
72Troubleshooting