S T E P 2

Scanning

Once you have set the magnification and scan mode, you may proceed with the scan. Once the scan is complete, Plug-in Module CS-U automatically closes and returns to the application software, such as CanoScan Toolbox CS or ArcSoft PhotoStudio 2000, if the [Close Plug-in After Scan] setting is on. The following provides an example of scanning from within ArcSoft PhotoStudio 2000.

To Initiate the Scan

Specify the Scan Area.

See Setting the Scan Area (p. 30).

Click on the [Scan] button.

The scan will start.

If a check mark is present in the [Close Plug-in After Scan] option in the [Preferences] menu, Plug-in Module CS-U will automatically quit when the scan finishes.

Hint

• The scan button cannot be clicked if the scan area is set too small (less than 64x64 pixels) or not specified.

The scan cannot be performed if the required memory is larger than the free memory.

33

Page 33
Image 33
Canon N656U, N1220U, N650U manual Scanning, To Initiate the Scan, Specify the Scan Area, Click on the Scan button