Getting Started
11
1

Installation Precautions

Avoid direct sunlight and

place in a cool location.

Do not install the copier in front of a window
that receives direct sunlight.
Do not install the copier in a high
temperature, high humidity location such as
in front of a heater or humidifier.
Avoid abrupt changes in temperature and
humidity, such as those caused by proximity
to a heater.
■ Recommended Conditions:
Temperature of 59°C to 81°F
Relative Humidity of 25% to 75%
InstallationInstallationPrecautionsPrecautions

Copier performance is affected by

environmental conditions. Please

observe the following precautions

when selecting a site to install the

copier.

Provide adequate

installation space.

It is necessary to provide adequate space
surrounding the copier to allow full
movement of the platen during copying.
■The minimum necessary operating
space:
32 1/8" (width) ✕ 17 3/8" (depth)

Provide proper ventilation.

Avoid dusty locations or locations where
ammonia gas is emitted.

Place on a flat, level surface.

Do not install the copier on an incline or
uneven surface.

Do not install near

televisions or radios.

Do not place the copier near televisions,
radios or other similar electronic equipment.
The copier might interfere with reception.
Plug the copier into a separate power outlet
and maintain as much separation as
possible.

Power Supply

• This copier is designed only for use with
the power source shown on the marking
label on the back of the copier. If you are
unsure if your power source meets these
needs, check with your local power
company.
• Do not plug this copier into a multi-plug
power strip.
• Do not allow anything to sit on top of the
power cord.

WARNING:

• If there is any unusual noise, smoke or anything
else which causes concern, immediately press
the power switch to OFF and unplug the copier
from its power source. Consult your service
representative.
Allow enough space in front of the power outlet
so that you can easily unplug the copier.