Turn on the Power Switch | ttMt Fjd | H' liPi |
@E~~Z6OJ~-~~ 1 Set the power switch to <ON>.
,l> The flash will start recycling.
Check that the flash is ready.
~The pilot lamp will first turn green (ready for quick flash), then red (fully recycled or flash ready).
~To fire a test flash, press the pilot lamp.
About Quick Flash
Quick flash enables a flash to be fired before
Although the Guide No. will be 1/6 to 1/2 that of the full output, quick flash is effective for near subjects and when you want a shorter recycle time.
Set the drive mode to Single. Quick flash cannot be used in the continuous shooting, FEB, manual flash, and stroboscopic flash modes.
About Auto Power Off
To save battery power, the power will turn off automatically after 90 sec. of idle use. To turn on the Speedlite again, press the shutter button halfway. Or press the Speedlite'stest firing button.
[l].;;. A test firing cannot be fired while the camera'soperation timer 04 or 06 is active.
1$ The Speedlite'ssettings will be retained in memory even after the power is turned off. To retain the Speedlite'ssettings when you replace the batteries, replace the batteries within 1 minute after turning off the power.
10
