
Connection Wizard
Encrypted Access Points
If the access point is encrypted (C), you will need to enter the encryption key (password). To find out the encryption key, refer to the instruction manual of the access point (wireless router) or consult the network administrator.
1[WEP]/[Shared Key] Select the WEP index key.
This step is only necessary if the
| Select [Input] and the press SET to |
| 2open the keyboard screen and enter the |
| encryption key. |
| Use the joystick or turn the SELECT dial |
| 3to select a character and then press |
| SET to add it. |
| After a moment, the character you entered will |
| change to “” to protect the password. |
| Use the arrows ( / / / ) to change the |
| position of the cursor and the backspace character |
| ( ) to delete the last character entered. |
| Repeat this step as necessary to enter the |
| encryption key. |
| After entering the encryption key, select |
| 4[OK] and then press SET. |
| Select [OK] and press SET to send the |
| 5encryption key. |
| Continue with the procedure to configure the IP |
| address assignment (A 15). |
Valid encryption keys vary depending on the encryption method. | |
5 ASCII characters or 10 hexadecimal characters. | |
13 ASCII characters or 26 hexadecimal characters. | |
AES / TKIP encryption: |
*Note: ASCII characters include the numbers 0 to 9, the letters a to z and A to Z and some punctuation marks and special symbols. Hexadecimal characters comprise the numbers 0 to 9 and the letters a to f and A to F.
12