24Recording

quality and as a result, also the available

recording time (

29).

Previous recordings overwritten by a new recording cannot be recovered. Before you start recording, search for the end of the last

recording (

 

 

26).

 

 

 

 

 

To protect the tape and video heads, the

camcorder will enter the stop mode (

 

) if left in

 

record pause (

) mode for 4 minutes 30

seconds. To resume recording press

Start/Stop .

When recording in very loud places (such as fireworks shows or concerts), sound may become distorted or it may not be recorded at

the actual levels. This is not a malfunction. About the Power Save mode: To save power when the camcorder is powered by a battery

pack, the camcorder will automatically shut off if left without any operations for 5 minutes

(

 

31). To restore the power, turn the

 

camcorder off and then on again.

About the LCD and viewfinder screen: The screens are produced using extremely high- precision manufacturing techniques, with more than 99.99% of the pixels operating to specification. Less than 0.01% of the pixels may occasionally misfire or appear as black, red, blue or green dots. This has no effect on the recorded image and does not constitute a

malfunction.

When using a tripod: Do not leave the viewfinder exposed to direct sunlight as it may melt (due to concentration of the light

by the lens). Do not use tripods with fastening screws longer

than 5.5 mm (0.2 inch). Doing so may damage the camcorder.

When recording movies, try to get a calm, stable picture.

Excessive camcorder movement while shooting and extensive use of fast zooms and panning can result in fidgety, jittery scenes. In extreme cases the playback of such scenes may result in visually induced motion sickness. If you experience such a reaction, immediately stop the playback and take a rest break as necessary.

Zooming

POINTS TO CHECK

( 9)

: In addition to the 35x optical zoom, the digital zoom (up to 1000x) is also available ( 28).

Zoom out

Zoom in

35x Optical Zoom

Move the zoom lever toward W to zoom out (wide-angle). Move it toward

Tto zoom in (telephoto).

You can also change the zoom speed

( 28). You can select one of three fixed zoom speeds or a variable speed that depends on how you operate the zoom lever: Press gently for a slow zoom; press harder for faster zooms.

NOTES

When set to [VARIABLE], the zoom speed will be faster in the record pause mode.

Keep at least 1 m (3.3 ft.) to the subject. At wide-angle, you can focus on a subject as close as 1 cm (0.39 in.).

Page 24
Image 24
Canon ZR800 instruction manual Zooming, 35x Optical Zoom, To zoom in telephoto