Playback

During playback there is video noise.

- Video heads are dirty. Clean the video heads ( 2).

Playback does not start.

-Load a cassette ( 29).

-Set the camcorder to ( 36).

-Tape reached the end (“ END” appears on the screen). Rewind the tape ( 29).

No sound from the built-in speaker.

-Open the LCD panel.

-Speaker volume is turned off. Adjust the volume with the [SPEAKER VOLUME] setting ( 36).

Image will not appear on the TV screen.

- Check again that the camcorder is properly connected to the TV ( 62).

Tape is running, but image will not appear on the TV screen.

-TV/VIDEO selector on the TV is not set to VIDEO. Set the selector to VIDEO ( 63).

-Video heads are dirty. Clean the video heads ( 2).

-You attempted to play back or dub a copyright protected tape ( 65). Stop playback/dubbing.

Memory Card

Operation

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Memory card cannot be inserted.

 

 

 

 

 

 

 

-

Memory card is not facing the correct direction. Turn the memory card over and reinsert it (

 

30).

 

annot record on the memory card.

 

 

 

 

 

 

 

-

Memory card is full. Erase still images (

 

54) to free some space or replace the memory card.

 

-

Memory card was not initialized. Initialize the memory card (

 

56).

 

 

 

 

 

 

 

-

The folder and file numbers have reached their maximum value. Set [FILE NOS.] to [RESET] (

 

 

78) and

 

 

 

insert a new memory card.

 

 

 

 

 

 

 

Memory card cannot be played back.

- Set the camcorder to ( 52).

Image cannot be erased.

-Image is protected. Cancel the protection ( 55).

-The write-protect switch on an SD or SDHC memory card is set to prevent accidental erasure. Change the position of the write-protect switch.

flashes in red.

-A memory card error occurred. Turn off the camcorder. Remove and reinsert the memory card. Initialize the memory card ( 56) if flashing persists.

Printing

The printer is not operating even though the camcorder and printer are correctly connected.

-Disconnect the USB cable and turn off the camcorder and the printer. After a short while, turn them on again,

set the camcorder to mode and restore the connection.

81