Carrier 48TC**16 Install Outside Air Hood, Economizer Hood Removal and Setup Factory Option

Step 8 — Install Outside Air Hood

Economizer Hood Removal and Setup -

Factory Option —

1.The hood is shipped in knock-down form and located in the return air compartment. It is attached to the economizer using two plastic tie-wraps.

2.To gain access to the hood, remove the filter access panel. (See Fig. 9.)

3.Locate and cut the (2) plastic tie-wraps, being careful to not damage any wiring. (See Fig. 10.)

4.Carefully lift the hood assembly through the filter access opening and assemble per the steps outlined in Economizer Hood and Two–Position Hood on page 10.

Two Position Damper Hood Removal and Setup - Factory Option —

1.The hood is shipped in knock-down form and assembled to a metal support tray using plastic stretch wrap. Located in the return air compartment, the assembly’s metal tray is attached to the basepan and also attached to the damper using two plastic tie-wraps.

2.To gain access to the hood, remove the filter access panel. (See Fig. 9.)

3.Locate the (2) screws holding the metal tray to the basepan and remove. In order to remove the screws, it may be necessary to remove the panel underneath the two-position damper. Remove the two screws. Locate and cut the (2) plastic tie-wraps securing the assembly to the damper. (See Fig. 11.) Be careful to not damage any wiring or cut tie-wraps securing any wiring.

4.Carefully lift the hood assembly (with metal tray) through the filter access opening and assemble per the steps outlined in Economizer Hood and Two–Position Hood on page 10.

5.If removed, reattach the panel under the damper.

48TC**16

FILTER ACCESS PANEL	Hood Parts
INDOOR COIL ACCESS PANEL
C10004
Fig. 9 - Typical Access Panel Locations
	Plastic Tie Wrap
	Qty (2)
Remove Hood Parts	Screws for Metal Tray
	Qty (2)
Cut Plastic Ties
(2) Places	C10006
Economizer	Fig. 11 - Two-Position Damper Hood Package Location
C10005
Fig. 10 - Economizer Hood Package Location

9