PRODUCT FEATURES AND BENEFITS (cont)
EASY ACCESS TO CHASSIS
Access to the chassis simply requires removing four screws and then sliding the chassis out of the sleeve for service.
CHASSIS ATTACHMENT SCREWS (SAME LOCATION ON OPPOSITE SIDE)
PLUG TEST/
RESET BUTTONS
Easy Service Access
HIDDEN CONTROLS
The
Temperature Limiter and Control Knob
The limiter reduces operating costs by allowing the owner to control the range of cooling and heating tem- peratures available to the occupant. It is located under the front panel on control box, out of the occupant’s sight. Each setting on the limiter is equivalent to 5° F and the range of temperature settings available to the owner is from 60 to 90 F. The limiter is not
Fan Cycle Switch
The fan cycle switch allows the fan to operate in
2 modes:
•Continuous — This setting allows the fan to run continuously, circulating air even when the temper- ature setting has been satisfied. This setting, which helps to keep the room temperature closer to the thermostat setting, is used for maximum comfort.
•Cycle — This setting allows the fan to cycle on and off with the compressor during heating or cooling. The fan stops when the temperature setting is reached. The longer unit
NOTE: On wall thermostat models, the fan cycle/ continuous feature is typically located at the wall thermostat.
Outdoor Air Vent Control
Control of the
The vent will provide 50 cfm of fresh air.
NOTE: If more fresh air cfm is required, a
10
