NOTE: The RED wire is not used in this application.. DO NOT remove the crimped cap from the wire..
1. Connect the green ground wire coming from the back of the
2. Check your work by using the wiring diagrams as shown in Figures # 1 and #2.
3. Install the
4. Install the wall plate with the two white screws.
2BLACK WIRES
Wall Control
RED WIRE
NOT USED
| BLACK AND WHITE |
Figure 2 | STRIPED WIRE |
Dual W-74 Installation
To control the fan and lights from two locations (a | DIP SWITCHES | |||||
circuit), use two |
| |||||
in Figure #4. Before installing the two switches into the wall, place |
| |||||
both switches side by side, then locate the 6 dip switches on the |
| |||||
side of the two switches as shown in Figure #3.Then make sure that |
| |||||
the dip switches are set to the same address on both switches as |
| |||||
shown in Figure #3. When setting these dip switches you are setting |
| |||||
the channel number that is required to control both your fan and |
| |||||
lights from both sides of the room. If you are installing other Direct- |
| |||||
TouchTM 3 fans within your home you may need to reset the dip |
| |||||
switches on these other fans to a different channel before installing |
| |||||
your |
| |||||
channel changing within this part of the operation manual as shown |
| |||||
on page #22. |
|
|
|
|
| |
|
| CAUTION! |
|
| Figure 3 | |
Ensure power is turned OFF at the breaker or fuse panel before starting installation. | ||||||
| ||||||
NEUTRAL |
| 1. To control the fan and lights from two | ||||
WHITE |
|
| ||||
|
|
| locations (a | |||
|
|
|
| |||
| GREEN | BLACK |
| wall controls. |
| |
|
|
|
| |||
|
|
| 2. Remove the screws and switch plate from the | |||
|
|
|
| existing switch box and the screws holding | ||
|
| BLACK |
| the switch in the switch box. Figure #5 | ||
|
|
|
|
| ||
|
| BLACK WITH | 3. | Pull the existing switch from the switch box to | ||
|
| WHITE STRIPE |
| expose the wire connections. |
| |
|
|
|
|
| ||
GREEN |
| GREEN | 4. | Determine which wire is connected to the | ||
|
| common terminal from the power source | ||||
|
| (120V AC) of the | ||||
BLACK WITH |
|
|
| |||
RED |
|
| terminal will be marked on switch). | |||
|
|
|
|
| ||
WHITE STRIPE |
| BLACK | 5. | Remove the wire from the common terminal | ||
| BLACK | |||||
|
|
| of the | |||
| RED | RED |
| |||
|
| the remaining black/white striped wire on the | ||||
| BLACK | BLACK |
| |||
|
|
|
| |||
|
|
| ||||
|
| RED |
| |||
120V AC | Figure 4 | BLACK |
| nut. Figure 4 |
| |
BLACK |
|
|
| |||
|
|
|
|
14