Direct - Touch
W-74 Control Installation
W-74 Wall control Preparation
|
| Switch |
|
|
| Mounting | Wall Plate | (4) Wire Cap | |
Wall Control | Cover Plate | Screws (2) | Screws (2) |
|
W-74 Wall Control Preparation
|
|
| Fuse Box | |||
Warning!To avoid possible electrical shock, | ||||||
(Remove fuse for the | ||||||
make certain that electricity is turned off at the | circuit you will be | |||||
circuit breaker or fuse box before attempting any |
|
| working on) | |||
installation or repair procedure |
|
|
|
|
| |
|
|
|
|
|
CAUTION! NOT turning the power OFF at the circuit breaker or fuse box may cause damage to the electronics within the wall control and or the PC board on the fan..
Installing the W-74 Wall Control
Circuit Breaker
(Trip breaker for the
circuit you will be
working on)
NOTE:
The wall control installs in the same manner as an ordinary light switch, using an existing wall box and wiring.This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed:
1. Use only the Casablanca | 3. Do not use more than one fan per wall control. |
2. Do not use any additional control with your | 4. No other light fixtures or electrical appliances may |
be connected on the circuit controlled by the | |
speed control). | wall control. |
Single W-74 Installation
CAUTION!
Ensure power is turned OFF at the breaker or fuse panel before starting installation.
1. If you have multiple
2. Remove the screws and switch plate from the existing switch box.
3. Remove the screws holding the switch in the switch box.
4. Pull the existing switch from the switch box to expose the wire connections.
5. Remove the two wires from the switch. |
|
|
6. Connect the BLACK wire from the POWER SOURCE |
|
|
that you just removed from the switch to the BLACK/ |
|
|
WHITE STRIP wire on the |
|
|
connection with a wire nut. |
|
|
7. Connect the second BLACK wire that you just removed |
|
|
from the switch to the second BLACK wire on the |
|
|
located on the back of the |
| Figure 1 |
connection with a wire nut. |
|
|
Red
White
Blue
13