Operation Lights
To turn the lights off and on, press and release the | button for less than |
one second. | Down Light |
|
Note: With CFL mode active, the lights will not dim.
To dim the down light, Press and hold the button for more than 1 second. The light will come on at the last brightness setting and increase in brightness until full power is reached, then start dimming until the lowest setting is reached.This cycle will repeat until you release the light button.
Operation CFL Mode
Note: The control with this fan has been shipped with CFL mode active..
Your fan has the ability to disable the dimming feature to allow the use of CFL bulbs.
To activate CFL mode: |
|
1. Turn the fan off by pressing the | power button. |
2. Allow the fan to remain off for at least 5 seconds.
3. Press the power button again to restore power to the fan.
4. Immediately press and hold the "1" and "3" buttons for at least 5 seconds.The fans lights will go to 100% brightness and the dimming function will be disabled.
To cancel CFL mode: |
|
5. Turn the fan off by pressing the | power button. |
6. Allow the fan to remain off for at least 5 seconds.
7. Press the power button again to restore power to the fan.
Caution: CFL bulbs will not function properly when dimmed, which may result in flickering or reduced bulb life.
8. Immediately press and hold the "2" and "4" buttons for at least 5
seconds.The fans lights will dim to 50% brightness and the dimming function will be enabled. Press and hold the light buttons until the desired dimmer setting is reached.
Changing Frequency Setting
You will only have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately.
NOTE: DO NOT set dip switch setting in the remote to ‘000000’, this may cause frequency interference from other Casablanca Products.. All fans leave the factory set to “111111”
DIP
SWITCHES
DIP SWITCHES SET TO ‘111111’ (Factory Setting)
(Figure 1)
DIP SWITCHES
SET TO ‘000000’
16
