Recording Your Keyboard Play

3. Press the (START/STOP) button.

This will start playback of the selected track.

4. When playback reaches the point you want to re-record, play the notes and perform the other operations you want.

This automatically starts punch-in recording, which will continue until step 5, below.

•Any one of the following also will start punch-in

recording: a pedal operation; pressing the

(RECORDER) button;*1 changing the tone setting; changing the rhythm or tempo setting*2.

*1 Press (RECORDER) when you want to start punch-in recording without note input or a setting

change.

*2 System track only

•You can perform (REW), (FF), and (PAUSE) button operations during punch-in playback to jump more quickly to the section you want to re-record.

5.To stop punch-in recording, press the (START/STOP) button again.

Anything in the track following the point where you pressed the (START/STOP) button will be retained as-is.

•If you want to delete all of the data in the track

following the section you re-recorded with punch-in

recording, press the (RECORDER) button in place of the (START/STOP) button above.

•If you want to cancel punch-in recording and retain the original (unedited) track data, hold down the (RECORDER) button until the display exits the punch-in recording screen.

Specifying the Punch-in Recording Location (Auto Punch-in Recording)

You can use the following procedure to specify a particular range for punch-in recording.

Start measure

End measure

Punch-in recording range

1. Turn on the recorder, enter the record mode, and display the recording setup screen.

•While holding down the  (FUNCTION) button, press the (RECORDER) button.

2.Use the  (u) and  (i) buttons to display “AutoPu.IN”, and then use the  (w, q) buttons to select the start measure.

3.Use the  (u) and  (i) buttons to display “AutoPu.OUT”, and then use the  (w, q) buttons to select the end measure.

•After selecting the start and end measures, press the  (EXIT) button to exit the recording setup screen.

4.Select the track that contains the range of measures you want to re-record.

•See step 3 under “Recording to a Specific Track (Part)” (page E-35).

5.Hold down the (RECORDER) button until the punch-in recording screen appears on the display.

6.Press the  (q) button to turn on auto punch-in recording.

7.Press the (START/STOP) button to start playback.

•Punch in recording will start from the start measure and stop with the end measure automatically.

8.Play the notes and perform the other operations you want.

E-38