Mixer Function

zChorus Send (Range: 000 to 127)

This parameter controls how much chorus send is applied to a part. A setting “000” turns chorus send off, while a setting of 127 applies maximum chorus send.

• “Chorus Send” does not work with drum sounds.

C h o S e n d

zDSP Line (Settings: on, oFF)

You can use this parameter to turn DSP line off for a particular channel, or to turn it on.

•Changing the tone, volume, pan pot, coarse tune, fine tune, reverb send, or chorus send setting causes the corresponding MIDI message to be output from the MIDI terminal.

•Changing the tone settings changes the tone, octave shift, reverb send, chorus send, and DSP line* parameter settings.

*When DSP is off (See the note on page E-24).

•Turning on the Mixer’s DSP line parameter (page E-24) causes the settings of the DSP Pan, DSP System Reverb Send, and DSP System Chorus parameters to be used in place of the Pan Pot, Reverb Send, and Chorus Send parameter’s settings.

DSP L i n e

DSP Part Parameters

zDSP Level (Range: 0 to 127) Sets the post-DSP volume.

DSP L e v e l

zDSP Pan (Range: –64 to 0 to 63) Sets the post-DSP stereo pan.

DSP P a n

zDSP System Reverb Send (Range: 000 to 127)This parameter adjusts how much reverb is applied to all parts.

D . R v b S n d

zDSP System Chorus Send (Range: 000 to 127) This parameter adjusts chorus.

D . C h o S n d

707A-E-041A

E-39