uTo replace the current animation with a new one

1.Select the point and curve for the new animation.

2.Tap [Edit], [Animate], and then [Replace Animation].

This discards the currently set animation and sets up an animation for a new point and curve set. Tap [Edit], [Animate], and then [Go (once)] to see your new animation.

uTo trace a locus of points

Note: Using trace leaves a trail of points when the animation is run. The procedure below is a continuation of the procedure under “To add an animation and run it”.

1.Draw a line segment that connects point A with apex B.

2.Draw the center point of line segment AB.

Select line segment and then tap [Draw] - [Construct] - [Midpoint].

3.Select the center point of line segment AB (point F) and then tap [Edit] - [Animate] - [Trace].

4.Tap [Edit], [Animate], and then [Go (once)].

This draws a line using point F as the locus, that is parallel to and whose length is half that of side CD of the parallelogram.

0804 To create an animation that traces the locus of specific points

uTo edit an animation

Note: The steps below continue from the procedure under “To trace a locus of points”.

1.While the animation you want to edit is on the display, tap [Edit], [Animate], and then [Edit Animations].

This displays the animation editing window in the lower window. The upper window contains the animation that we just completed in “To trace a locus of points”.

2.Edit the animation following the procedure below.

Steps:

This setting specifies how many steps point A takes to move along side CD. The initial default value is 20, which can be changed to value from 2 to 100.

Animations:

The “A” under “Animations” indicates that point A is the point moved by the

animation. When you are building multiple animations, a list of all applicable points appears here. Tapping [Remove] deletes the applicable animation.

Chapter 8: Geometry Application

168