uClassPad Operation

1.Use the procedure under “Connecting to Another ClassPad Unit” above to connect the two units.

2.Use the procedure under “To configure communication parameters” (page 249) to configure the parameters of the two units as shown below.

• Cable Type: 3pin cable

• Speed (3Pin): 115200 bps

• Wakeup Enable: On

On the sending ClassPad:

3.On the Communication application window, tap [Link] - [Transmit], or tap E.

This displays the Select Data dialog box. A list that shows user folders and the “main” folder appears first.

4.Select the data you want to send.

(1)Tap the [View] menu and then select the data type from the list that appears.

To list this on the Select Data dialog box:Select this [View] menu command:

User folders and the “main” folder

Data Folder List

 

 

Library variables

Library

 

 

System variable groups

Application Status

 

 

eActivity folders

eActivity Folder List

 

 

(2)Select the data you want to send.

On the Select Data dialog box, select the check box next to the data you want to send. You can also tap the [All] menu and select one of the following commands to select or deselect data.

To do this:

Select this [All] menu command:

Select all currently displayed items

Select List

 

 

Deselect all currently displayed items

Deselect List

 

 

Select all items in all lists

Select All Lists

 

 

Deselect all items in all lists

Deselect All Lists

 

 

Opening a folder in [Data Folder List] or [eActivity Folder List] displays the variables and data contained inside it, which can be individually selected for transfer. To select a variable or data contained in a particular folder, tap its folder name to open it. To return to the folder list from a list of folder contents, tap I in the lower left corner of the window.

You can transfer all of the variables or data in a folder by selecting the check box next to the folder name on the data folder list or eActivity folder list.

5.Tap [OK].

6.In response to the confirmation message that appears, tap [OK] to send the data.

This sends the data you selected in step 4, and the receiving ClassPad automatically starts receiving the data.

The message “Complete!” appears to let you know when the send operation is finished.

7.Tap [OK] to return to the Select Data dialog box.

8.On the Select Data dialog box, tap [Cancel].

This returns to the Communication application window.

On the receiving ClassPad:

9. The message “Complete!” appears to let you know when the receive operation is finished. Tap [OK].

Chapter 15: Performing Data Communication

256