Using an SD Memory Card

5. Use the + and – buttons to select the file

2.

number where you want to save the song

 

data.

 

This mark indicates that the currently displayed song number has data stored already.

3.

6. When everything is the way you want, press the TEMPO/SETTING button to begin saving data.

•The message “CPL” (ComPLete) will appear on the display to let you know when the save operation is complete.

zTo interrupt an ongoing save operation, press the CARD button.

zIf the SD memory card already contains a data file with the same file number, pressing TEMPO/ SETTING in step 6 will display “rEP” (rEPlace) to

confirm that you want to replace the existing file with the file you are saving. Press the S/YES button to replace the file.

•To cancel the operation, press the T/NO button in place of the S/YES button.

Formatting an SD Memory

Card

Use the procedures in this section to format an SD memory card.

IMPORTANT!

•Before performing the procedure below, check to make sure that the SD memory card does not contain any data you might need.

•The SD memory card format performed by your digital piano is a “quick format”. If you want to completely delete all of the data on the card, format it on you computer or using some other device.

PREPARATION

•Insert the SD memory card you want to format into the digital piano’s SD memory card slot. Make sure that the write-protect switch of the SD memory card is not in the write-protect position.

1. While holding down the TEMPO/SETTING button, press the CARD button. Keep the TEMPO/SETTING button depressed until you finish step 2 of this procedure.

•This will cause “For” (Format) to appear on the display.

Press the S/YES button to start formatting.

•“PLS” (PLeaSe wait) remains on the display while the formatting operation is performed. Never try to perform any other operation on the digital piano while the memory card is being formatted. The message “CPL” will appear on the display to let you know when the format operation is complete.

zTo cancel the format operation, press the T/NO button in place of the S/YES button.

Release the TEMPO/SETTING button to complete the formatting procedure.

•This causes the indicator lamp above the button to turn off.

E-33