Assembling the Stand
Unpacking
PREPARATION
•Before starting assembly, check to make sure that you have all the parts shown below. You can find the screws in a plastic bag inside of the polystyrene foam packing material.
•This stand does not include any of the tools required for assembly. It is up to you to prepare a large Philips head
(+) screwdriver for assembly.
B
C
|
| D |
|
A |
|
|
|
|
| E |
|
F |
|
|
|
|
| I (a) | (b) |
G |
|
|
|
H |
| J |
|
|
|
| |
|
| K |
|
A Side panel ........................... | ×1 | H Crips.................................... | ×2 |
B Side panel ........................... | ×1 | I Bracket................................ | ×1 |
C Speaker box ........................ | ×1 | J Screw caps (Black) ............. | ×2 |
D Screws ................................ | ×8 | K Polystyrene foam packing | |
E Screw caps (Brown) ............ | ×8 | material (Required for stand | |
F Pedal unit ............................ | ×1 | assembly.)........................... | ×1 |
G Screws ................................ | ×2 |
|
|
Assembling the Stand
CAUTION
•The stand should be assembled by two people working together.
•The stand should be assembled on a flat surface.
•Do not remove the tape securing the keyboard cover in place until assembly is complete. Removing the tape can cause the keyboard cover to open and close during assembly, creating the risk of personal injury to your hands and fingers.
•Take care that you do not pinch your fingers between parts when assembling them.
•When placing the digital piano on the floor, be sure to place it on something soft (a blanket, cushion, etc.). Do not place the digital piano directly onto the floor.
NOTE
•When attaching the digital piano and the speaker box C to side panels A and B, lay the entire assembly on its side.
•Be sure to follow the proper procedure when assembling the stand. Be especially careful in the case of steps 2 and 3. Reversing these two steps creates the risk that the connector will not be plugged in fully.