
Projection Operations
Manually Selecting the Input SourceThe procedure you should use to select the input source depends on whether you are using projector keys or remote controller keys.
[VIDEO] key
[RGB/COMPONENT] key
[Projector] | [INPUT] key | [Remote Controller] |
zTo select the input source using projector keys, press the [INPUT] key on the projector to cycle through input sources in the sequence shown below.
(RGB/Component) | (VIDEO) |
zTo select the input source using remote controller keys, press the [RGB/COMPONENT], [VIDEO], or
The currently selected input source name is shown in the upper right corner of the projection screen.
zIf the currently selected input source is not sending an input signal, the message “No signal input” appears in place of the input source name.
zThe input source name when RGB/Component is selected as the input source is displayed as “RGB” or “Component” in accordance with the “Detailed Settings J Advanced Settings 2 J RGB Input” on the setup menu (page 44). For more information,
see the note under “Auto Input Source Selection” (page 5).
6