TIMER TO
CLOSE
OFF MAX

OPERATION AND MAINTENANCE

IMPORTANT SAFETY INSTRUCTIONS

WARNING

To reduce the risk of SEVERE INJURY or DEATH:

1.

READ AND FOLLOW ALL INSTRUCTIONS.

5.

Use the emergency release ONLY when the gate is not

2.

NEVER let children operate or play with gate controls. Keep

 

moving.

 

the remote control away from children.

6.

KEEP GATES PROPERLY MAINTAINED. Read the owner’s

3.

ALWAYS keep people and objects away from the gate. NO

 

manual. Have a qualified service person make repairs to

 

ONE SHOULD CROSS THE PATH OF THE MOVING GATE.

 

gate hardware.

4.

Test the gate operator monthly. The gate MUST reverse on

7.

The entrance is for vehicles ONLY. Pedestrians MUST use

 

contact with a rigid object or stop when an object activates

 

separate entrance.

 

the non-contact sensors. After adjusting the force or the

8.

Disconnect ALL power BEFORE performing ANY

 

limit of travel, retest the gate operator. Failure to adjust and

 

maintenance.

 

retest the gate operator properly can increase the risk of

9.

SAVE THESE INSTRUCTIONS.

 

INJURY or DEATH.

Using Your Gate Operator

Your operator will operate with up to nine Security✚® remote controls and one Security✚® Keyless Entry System. If you purchase a new remote, or if you wish to deactivate any remote, follow the instructions in the Programming section.

Activate your operator with any of the following:

Hand Held Remote Control (See Accessories): Hold push button down until the gate begins to move. While gate is moving, the next command sent from the remote will stop the gate. Next command will reverse the gate direction.

Keyless Entry (See Accessories): If provided with your gate operator, it must be programmed before use. See Programming.

Vehicle Exit Sensor: See accessory page.

Automatic Timer To Close Feature

The Timer-To-Close (TTC) Feature comes from the factory in the OFF setting.

The “TIMER RUNNING LED” will flash once for every second of adjusted time. The gate(s)

must fully open for the timer feature to be active and close the gate(s). Any radio

command or pressing the single button on the control board prior to the TCC time expiring will close the gate. The TTC is reset by any signals from the loops, close edges, and close safety sensors (IR’s).

Entrapment Features

When the operator is activated (with the safety sensors correctly installed and aligned) and the safety sensors encounter an obstruction, the following will occur:

Opening Cycle: Gate will stop, reverse direction for approximately 2 seconds and then stop. The next command will continue the gate in the close direction.

Closing Cycle: Gate will stop, reverse direction for approximately 2 seconds and then stop. The next command will open the gate.

Alarm Sounds

Party mode

If the Timer-to-Close feature is enabled and you would like the gate to remain open, simply push the reset button (located on the outside of the control box). The next command given to the operator will close the gate and return the operator to normal operation.

Sleep mode (battery conservation)

Sleep Mode (Battery Conservation): The operator enters sleep mode 10 seconds after the last command is given. The diagnostic LED will blink in this mode. The safety sensors (photo eyes) indicator LEDs will not be on. The next operation command will return

the operator to normal operation.

The operator alarm will sound under the following condition: If gate encounters two consecutive obstructions, the operator will stop, the alarm will sound (up to 5 minutes) and the control board will require resetting. Reset the control board by pressing the “Reset Button” located on the

outside of the control box. No commands at this time will

 

operate gate. After the operator is reset, normal functions

 

will be available.

 

Operation and Maintenance

36

RESET RESET