Using the Wall-Mounted Door Control
THE MOTION DETECTING CONTROL CONSOLE
Press thepush barto open or ctose the door.
Press again to reverse the door
during theclosing cycleor to
stop the door while it's opening.
This door control contains a
motion detector that will
automatically turn on the light
when it detects a person entering
the garage.. This feature can be
easily turned off for extended
work lightuse.
Light feature
Push
Bullon
Dr
/
LOCl
Button Ught
Bulton
Press theLight button to turn the opener light on or off.. It
will not control the opener lights when the door is in
motion..If you turn it on and then activate the opener, the
light will remain on for 4-t/2 minutes_Press again to turn it
off sooner. The 4-1/2 minute interval can be changed to
1-1/2, 2-1/2 or 3-I/2 minutes as follows: Press and hold
the Lock button until the light blinks (about 10 seconds). A
single blink indicates that the timer is reset to 1-1/2
minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes,. Repeat again
for a 3-I/2 minute interval, etc..,up to a maximum of four
blinks and 4-1/2 minutes..
When using the opener lights as working lights, we
recommend that you first disable the motion sensor See
Motion Detecting Light Feature, following.
Motion Detecting Light Feature: The opener light will
turn on automatically when a person walks in front of the
wai!-mounted control console. This feature works by
detecting motion and body heat and may not work in
temperatures around 100°F, 37._7C_The opener light will
come on for 5 minutes, then shut off automatically if no
additional motion or heat differential is calculated..
To disable this feature, slide the Detector Switch on the
right side of the door control down (off)..
We recommend that you disable the motion sensor when
using the opener lights as working lights.. Otherwise, they
will turn off automatically if you are working beyond the
sensor's range.,
Lock feature
Designed to prevent operation of the door from hand-held
remote controls_ However, the door will open and close
from the DoorControl, the Outside Keylock and the
Keyless Entry Accessories_
To activate, press and hold the Lock button for 2 seconds..
The push bar light will flash as long as the Lock feature is
on,,
To turnoff, press and hold the Lockbutton again for
2 seconds,The push bar light will stop flashing The Lock
feature will also turn off whenever the "Smart" (learn)
button on the motor unit panel isactivated..
Additional feature when used with the
3-button hand-heM remote
To control the opener lights:
I..With the door closed, press and
hold a small remote button that you
want to control the lighL
2_Press and hold the Light button on the control console..
3.While holding the Light button, press and hold the Lock
button on the control console..
4.After the opener lights flash, release all buttons.
32