ADJUSTMENT STEP 1
Program the Travel Limits
Travel limits regulate the points at which the door will
stop whenmoving up or down. Follow thesteps below
to set the limits.
Toprogram the travel limits:
Figure 1° o
tndic_torUght
-Black Buttot_
-PurpleBlJtlon
Adjust theposition of the door by using the black and
purple buttons..Black moves the door UP (open) and
purple moves the door DOWN (close).
1..Setting the UP position: Press and hold the black
button until the yellow indicator light starts flashing
slowly then release,,
2oPush and hold the bIack button untit the door reaches
the desired UP (open) position (Figure 2)..
NOTE: Check to be sure the door opens high enough for
your vehicle..
3oPush the remote control or door control (Figure 3). This
sets the UP (open) limit and begins closing the door,.
4..Immediately when the door begins to move down, press
and release either the black or purple button..This will
stop the door..
5 Setting the DOWN position: Push and hold the purple
button until the door reaches the desired DOWN
(closed) position (Figure 4),
6..Once the door is closed, ifthere appears to have too
much pressure on the door, you may toggle the door
back and forth using the black andpurple buttons to
reach the desired closed position.
7, Push the remote control or the door control (Figure 3)7
This sets the DOWN (close) limit and should bring the
door to the open position,,
- If the opener is not stopping exactly where you
would like it, repeat steps 1 through 7 and program
the limitsagain.
= When the unit stops in both the desired up (open)
and down (close) positions, proceed to
Adjustment Step 2, Setting the Force..
Withouta properlyinstalledsafetyreversalsystem,persons
(particularlysmallchildren) could be SERIOUSLYINJUREDor
KILLEDbya closinggaragedoor.
°Incorrect adjustmentof garagedoor travel limits will interfere
with proper operationof safetyreversal system,
=NEVERuseforceadjustmentsto compensatefora binding or
stickinggaragedoor_l
• AfterANYadjustmentsare made,the safetyreversalsystem
MUSTbetested.Door MUSTreverseon contact with 1-1/2"
(38 cm) high object (or 2x4 laid flat) on floor,.
Topreventdamageto vehicles,be sure fully opendoor
providesadequateclearance,
Indicator Ught
Figure 2
Push andhold
" until thedoor
isat desired UP
posilion
Figure 3
OR
Figure 4
Indicator Ught
Pusheither ._
button toslop _,*-_.
doora,desiredll_l
DOWN position [J---_-- U
28