ALL ONE-PIECE DOORS
1, Assemble the Door Arm:
oFasten the straight and curved door arm sections
together to the longest possible length (with a 2or 3
hole overlap) (Figure 4)..
• Make sure the garage door is fully closed. Connect
the straight door arm section to the door bracket with
the 5/16"x1-1/4" clevis pin
oSecure with a ring fastener.
oPull the emergency release handle, disconnecting the
outer trolley from the inner trolley by pulling straight
down on the emergency release handle and sliding
the outer trolley back toward the motor unit..
• Connect the curved door arm section to the trolley
using the 5/t6"x1-1/4" clevispin and ring fastener..
NOTE: Adjusting the limits on the following page:'
•The trolley willautomatically connect., if not, review the
trolley lockout feature on page 33..
•When setting the up limit on the following page, the
door should not have a "backward" slant when fully
open asillustrated below.. Aslight backward slant will
cause unnecessary bucking and/orjerking operation
as the door is being opened or closed from the fully
open position (Figure 5)..
Figure 4
Door
Doe_ Arm
Figure 5 Inner Trolley
EmergeL_ nc'j Release Handte
Closed
I Door
InnerTrolley
Open Door (lncorrecl)
27