7"o Add, Reprograrn or C_ange a Keyless EnEry PINNOTE: Yournew Keyless Entry must be programmed tooperate your garage door opener,USING THE "LEARN" BUTTON USING THE MOTION DETECTING CONTROL
1..Press and release the "learn" button
on motor uniL The learn indicatorlight
will glow steadily for 30 seconds..
2. Within 30 seconds, enter a four digit
personal identification number (PIN) of
your choice on the keypad. Then
press and hold the ENTER button.
3. Release the button when the motor
unit lightsbiink., it has learned the
code If light bulbs are not installed,
two clicks will be heard.,
To change an existing, known PIN
If the existing PIN is known, it may be changed by one
person without using a ladder..
1..Press the four buttons for the present PIN, then press
and hold the # button..
The opener light will blink twice. Release the # button
2..Press the new 4-digit PIN you have chosen, then
press Enter.
The motor unit lights will blink once when the PIN has been
learned..
Test by pressing the new PiN, then press Enter.,The door
should move,
To set atemporary PIN
You may authorize access by visitorsor service people with
a temporary 4-digit PIN. After a programmed number of
hours ornumber of accesses, this temporary PIN expires
and will no longer open the door.. It can be used to close the
door even after it has expired_To set a temporary PIN:
1..Press the four buttons for your personal entry PIN (not
the last temporary PIN), then press and hold the =I=
button..
The opener light will blink three times, Release the
button..
NOTE: This method requires two people if the Keytess
Entry is already mounted outside the garage,.
1..Enter a four digit personal identification
number (PIN) of your choice on the
keypad.. Then press and hold ENTER,.
2. While holding the ENTER button,
press and hold the LIGHT button on
the Motion Detecting Door Control.
3Continue holding the ENTER and
LIGHT buttons while you press the
push bar on the Motion Detecting Door
Control (all three buttons
are held)..
4,, Release buttons when the motor unit
lights blink_It has learned thecode.. If
light bulbs are not installed, two clicks
will be heard,.
2oPress the temporary 4-digit PIN you have chosen, then
press Enter,
The opener light will blink four times
3.,To set the number of hours this temporary PIN will work,
press the number of hours (up to 255), then press :I:.
OR
3..To set the number of times this temporary PIN will work,
press the number of times (up to 255), then press #..
The opener light will blink once when the temporary PIN has
been learned
Test by pressing the four buttons for the temporary PIN,
then press Enter. The door should move. Ifthe temporary
PiN was set to a certain number of openings, remember
that the test has used up one opening, To clear the
temporary password, repeat steps 1-3, setting the number
of hours or times to 0 in step 3o
One Button Close: Opener can be closed by pressing onty the ENTER button if the one button close feature has been
activated. This feature has been activated at the factory. To activate or deactivate this feature press and hold buttons 1 and 9
for 10 seconds. The keypad will blink twice when the one button close isactive. The keypad will blink four times when one
button close is deactivated.
38