CM2 | Installation Instructions |
6.Route cable(s) down through opening at rear of middle cable clamp mounting bracket. (See figure 19) and (See figure 20)
NOTE: If plug on cable will not fit through opening loosen or remove one screw securing middle cable clamp mounting bracket to mount frame and pivot middle cable clamp mounting bracket to the side until plug can be routed behind bracket.
CAUTION: Bracket mounting hardware MUST be reinstalled and tightened before continuing with cable installation. (See figure 20)
x1 | 5 |
| |
| 6 |
Figure 20
7.Route cable under cable pulley and up through front cable clamp on middle cable clamp mounting bracket.
(See figure 19)
8.Loop cable and route cable down through side cable clamp(s) on middle cable clamp mounting bracket. (See figure 19)
CAUTION: Cables must not extend higher than 1" (25mm) above cable mounting bracket when looped! (See figure 19)
9.Route cable(s) down through lower cable clamp(s). (See figure 19)
10.Route cable through cable access opening in top of mount base and cable access opening in side of mount base. (See figure 19)
11.Tighten upper cable clamp making certain cables are properly seated in clamp and are not pinched.
WARNING: OVERTIGHTENING OF CABLE CLAMPS CAN CRUSH CABLES LEADING TO DAMAGE TO EQUIPMENT! DO NOT over tighten cable clamps.
12.Starting at upper cable clamp and working downward, remove slack from all cables and tighten remaining cable clamps. (See figure 19)
13.Slide cable guide side cover over cable guide making certain lip on back cover plate is fully seated in groove in cable guide side cover. (See figure 21)
Back Cover Plate |
Cable Guide |
Side Cover |
13 |
Figure 21
14.Secure cable guide top cover to mount and cable guide side cover, using two screws.
x2 |
14 |
Figure 22
12
