CM2 | Installation Instructions |
NOTE: Verify that there is at least 1" of clearance between bottom of display and mount base.
3.If there is less than 1" of clearance, remove the display and refer to Adjusting Faceplate Location section, and adjust display height accordingly.
NOTE: Holes are provided in the faceplate for use with a padlock or similar locking device, if desired. In addition, the pin and nut may be removed from the upper holes and moved to the lower holes for use as a more permanent locking device. (See figure 10)
Shelf Height Adjustment
After the CM2 has been properly configured for the display and the display installed, the shelf height needs to be adjusted to the top of the display.
To set shelf height:
1.Using the remote control, raise lift until locknutssecuring right and left shelf adjustment brackets can be accessed.
1 |
Display removed |
for clarity |
Figure 11
2.Loosen four nuts securing right and left hand shelf adjustment brackets to faceplate mounting bracket.
3.Slide shelf adjustment brackets upward until top of brackets are positioned higher than top of display.
| Display and Faceplate |
3 | removed for clarity |
| 2 |
| X4 |
Figure 12
4.
4 | Top of Display |
|
Figure 13
5.Shelf and shelf mounting brackets down until shelf is 1/4" (6.5mm) above top of display.
6.Tighten four nuts to secure shelf mounting bracket in position.
WARNING: IMPROPER INSTALLATION CAN LEAD TO SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Make sure all four nuts are tight before continuing installation!
| 1/4" (6.5mm) min. |
4 |
|
5 | X4 |
Figure 14
8
