Chief Manufacturing CM2 If more than 2 of faceplate adjustment is required

CM2			Installation Instructions
		9.	Secure faceplate to faceplate mounting bracket using two
	6		locknuts. (See figure 6)
6	10
10
			9	x2
			Figure 5
4	5	10.	Using the remote control, lower the lift until it stops.
			(See figure 3)
		If more than 2" of faceplate adjustment is required:
		11.	Raise lift following instructions in step 6. (See figure 3)
		12.	Loosen four nuts securing faceplate mounting bracket to
			frame. (See figure 6)

	Figure 3	13.	Slide faceplate mounting bracket upward desired amount.
7.	Remove two locknuts securing faceplate to faceplate	14.	(See figure 6)
	mounting bracket. (See figure 4)		Tighten four nuts to secure faceplate mounting bracket to
8.	Move faceplate up one set of holes to adjust location 1" or		frame.
	two sets of holes to adjust 2". (See figure 4)

1"
(25MM)
8
8
7	x2

Figure 4

WARNING: IMPROPER INSTALLATION CAN LEAD TO SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Make sure all four nuts are tight before continuing installation!

13
12	X4
14	X4

Figure 6

6