(Optional) Installing Wiring Cover
An optional wiring cover may be installed to further protect wiring from mechanical damage.
WARNING: Make sure that power to
1.Remove the control harness. (See Figure 9)
2.Using four Phillips head screws, attach cover (included in kit) over hole created in Step 1.
3.Make control connections directly to the control box. (See Inside Terminal Wiring Examples sections.)
4.Remove and save two Phillips head screws from opposite corners of cover plate, and remove cover plate from
NOTE: Some components not shown for clarity.)
Cover
Plate
5 | x 2 |
Switch Hole
Cover
Motor Wiring
Cover
5.Place switch hole cover behind the cover plate and attach with two Phillips head screws from the kit.
6.Replace cover plate and attach using two Phillips head screws removed in Step 4.
7.Remove three Phillips head screws from
8.Place motor wiring cover in place and attach with three Phillips head screws removed in Step 7.
9.Remove three Phillips head screws from
10.Place control wiring cover in place and attach with three Phillips head screws removed in Step 9.
x 4 | Control | |
Harness | ||
| ||
| 2 |
1
Control Wiring
Cover
| 7 |
|
|
4 | x 2 | x 3 |
|
| 8 | 9 | x 3 |
6 | x 2 |
|
|
|
| 10 | x 3 |
Figure 9
11