Instruction Manual | |
|
|
|
|
INSTALL THE PROJECTOR ON THE LIFT
CAUTION: Improper projector weight distribution could lead to equipment damage. Make certain projector weight is centered on cradle when mounted.
1.Install the SLB bracket on the projector (see the SLB manual for details).
2.Remove the yaw adjustment bracket from the lift (see Figure 9).
3.Place the yaw adjustment bracket over the studs on the SLB as shown, selecting the set of holes that best centers the weight of the projector.
4.Install tapered thumb nuts (minimum 3), making sure the tapered end is toward the projector.
5.Reinstall the yaw adjustment bracket with projector attached.
NOTE: If desired, the projector can be set directly on the bottom plate of the lift, not secured by the bracket. The bracket may be removed for esthetic purpose by removing four roll/height adjustment nuts (see ADJUSTMENTS).
Install and Route Cables | Figure 9. Install Projector |
CAUTION: Do not attach cables to lower lifting arms or sides of cradle. This may result in damage when lift retracts.
NOTE: Two routing paths are provided, one on each side, to sepa- rate electrical and video cables.
1.Lower lift to service position.
2.Route and secure all electrical and video cables using ties and eyelets provided (see Figure 10), leaving some slack between securing points.
3.Plug the projector’s power cord into one of the two outlets inside the lift. One outlet is switched and the other is continu- ously live. The switched outlet is marked with an “S”.
Figure 10. Cable Routing Example
12