Chief Manufacturing SL-236 installation instructions Outside Terminal Wiring Examples, Push Button

Instruction Manual SMART-LIFT 236 Electric Ceiling Lifts

OUTSIDE TERMINAL WIRING EXAMPLES

The information on the following pages cover the most common wiring options:

•Supplied Momentary Push Button

•Discrete Extend and Retract for switch or dry contacts

•12 Volt out supply

•24 Volt out supply

•Two dry contact closures

•Service Extend

CAUTION: Closing the unit while the projector is running may cause premature bulb failure and may damage both the lift and pro- jector.

Push Button

Figure 13. 24VAC Internal

Supplied Single Pole Single Throw (SPST) Switch

Using Internal 24VAC Power Supply

a.Connect the green jumper wire (supplied) to terminals 1 & 5 (see Figure 13).

b.Connect the SPST switch (supplied) to terminals 2 & 6.

Supplied SPST Switch Using Internal 12VDC Power Supply

a.Connect the green jumper wire (supplied) to terminals 5 & 9 (see Figure 14).

b.Connect the SPST switch (supplied) to terminals 6 & 10.

Supplied SPST Switch Using External Power Supply

a.Connect the negative of your power supply to terminal 5 (see Figure 15).

Figure 14. 12DC Internal

b.Connect the SPST switch (supplied) to terminal 6 & the pos- itive of your power supply.

Figure 15. External Power Supply

14