![](/images/new-backgrounds/1173562/17356231x1.webp)
Preparation
Remote Control Transmitter
This wireless remote control uses radio frequency signal. You can switch four frequency channels prepared and select a remote control ID from eight IDs. The Remote Control Channel selection prevents radio frequency interference from the other equipment and the Remote Control ID selection allows you to operate several projectors with their respective remote controls without mutual interference among those projectors.
Wired Remote Control Transmitter
The remote control can be used as a wired remote control. When interference between the projector and other equipment occurs or the projector is used in a place where the operation of radio equipment is restricted, connecting the remote control and the projector with the wired remote cable
Remote Control Channel and ID Setup
Initial Remote Control Channel and ID are CH1 and ID1. When you change the setting, set a Channel first, and then an ID.
C A N C E L
MENU | INFO | AUTO PC |
FREEZE SCREEN
Channel and ID settings for the remote control should be the same as those for the projector. When changing the CH and ID settings to the remote control, do it to the projector as well. Refer to "Remote Control " in Setting menu on page 51.
VOL.
SOUND | INPUT 1 | |
MUTE |
|
|
| INPUT 4 | INPUT 2 |
CH |
|
|
REMOTE | INPUT 5 | INPUT 3 |
CH button
ID ID button
Should you be lost at which CH and ID are currently set, initialize the Channel and ID once, and set them again.
REMOTE RESET ON ALL OFF
1 Set the Remote Control Channel
Hold down the CH button and press the SELECT button. The Remote Control Channel switches sequentially for one pressing the SELECT button. (See Table1 on next page.)
2 Set the Remote Control ID
Hold down the ID button and press the SELECT button. The Remote Control ID switches sequentially for one pressing the SELECT button. (See Table2 on next page.)
Initialize the Remote Control Channel and ID
Press and hold the CH and ID buttons, and slide the REMOTE
✔Note:
Remote Control Channel and ID cannot be initialized separately.
SELECT button
While pressing the CH/ID button, press the SELECT button number of times corresponding to the remote control CH/ID.
16