Cisco Systems 3515 MCU12, 3515 MCU24 manual Changing the Configuration Software Password

Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU

How to Perform the Video Processing Module Initial Configuration

Caution Configuration of any of the parameters other than N: Configure default network port values may alter the function of the device and should not be performed by an unauthorized person.

Changing the Configuration Software Password

You can use the serial port to change the configuration software password.

Procedure

Step 1 At the prompt, enter P to change the configuration software password and press Enter. The user profile screen appears as follows:

Enter user name:

Enter new password:

Step 2 At the Enter user name prompt, enter the new user name and press Enter.

Step 3 At the Enter user password prompt, enter the new password and press any key to return to the video processing module Main menu.

Changing the Security Level

You can use the serial port to change the security level. Security levels are as follows:

•0 (low)—Allows SNMP, Telnet, HTTP, FTP, and ICMP to access the MCU.

•1 (medium)—Allows access to the MCU only through SNMP, HTTP and ICMP.

•2 (high)—Allows only HTTP to access the MCU.

Procedure

Step 1 At the prompt, enter S to configure the network security level and press Enter.

The security level screen appears as follows:

The current security level is [0 low].

Enter a new security level (0-low, 1-medium. 2-high):

Step 2 Enter the new security level required and press Enter.

The updated security level screen appears as follows:

The current security	level is [0 low].
Enter a new security	level (0-low, 1-medium. 2-high):
2
Board security level	changing to [2 high]:
Set icmpRequestBlock	to 2

The new security level is [2 high].

Step 3 The video processing module Main menu displays.

	Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU Release 5.6
2-10	OL-17012-01