How Do I Install Wireless Network Devices?
To install wireless network devices
WARNING:
Hazardous electrical voltages can be present on any connected wiring. Ethernet wiring and connections must be properly insulated to prevent electrical shock. Disconnect power from the cable modem gateway before attempting to connect to any device.
To avoid personal injury, follow these steps in the exact order shown.
CAUTION:
To prevent possible damage to the equipment, disconnect any other service before connecting your cable modem gateway to other devices.
Read the warnings and caution on this page. Then, follow the subsequent installation procedures to ensure proper cable modem gateway operation when using wireless network devices.
Installing Wireless Network Devices
Follow these steps to install the cable modem gateway for accessing wireless network devices.
1Select locations for wireless network devices. For more information, see How Do I Select and Place Wireless Network Devices? (on page 40).
2Connect and install the wireless network device(s).
3Connect the active RF coaxial cable to the CABLE connector on the back of the cable modem gateway. Use an optional cable signal splitter to add a TV, a DHCT or
4After all connections are complete, insert the AC power cord into the POWER connector on the back of the cable modem gateway, and then plug the power cord into an AC power source. The cable modem gateway begins an automatic search to locate and sign on to the network. In some unusual circumstances, this process may take up to 5 minutes. The cable modem gateway is ready for use when the ONLINE LED status indicator on the front panel stops blinking and illuminates continuously.
Note: Some 2.4 GHz cordless telephones can interfere with wireless signals. Unplug and disconnect any cordless phones until your wireless network is operating properly.
5Verify that all wireless network devices are working properly.
42 | 4011533 Rev A |