How Do I Configure the Cable Modem Gateway?

To set up your password

To set up your password, type your password in the Password field, and then re-type your password in the Re-Enter Password field. Then, click Apply to save your password.

Note: If you set a password, on subsequent access to the WebWizard pages, a screen similar to the following appears. Do not forget your password. Write your password and store it in a secure location known only to you.

Configuring Network Time Synchronization

Use the Basic Settings Enable/Disable time synchronization by Network Time protocol page to enable or disable time synchronization by Network Time protocol.

Note: If you are not familiar with the time configuration procedures detailed in this section, contact your service provider before you attempt to change any of the cable modem gateway default time synchronization configuration settings.

Click Set Time in the Basic Settings section of the Setup page to access the Basic Settings Enable/Disable time synchronization by Network Time protocol page.

4011533 Rev A

53