Chapter 3 Installing the Cisco Global Site Selector 4490

Removing or Replacing a Cisco Global Site Selector 4490

To physically remove a GSS from your network:

1.Power down the GSS by pressing the power button on the front panel of the GSS.

2.Disconnect the power cords and network cables.

3.Physically remove the chassis from the rack.

To physically replace a GSS, install the new GSS and configure it using the same configuration parameters (such as IP address) that you used for the removed GSS. Refer to the Cisco Global Site Selector Getting Started Guide for details.

 

Cisco Global Site Selector 4490 Hardware Installation Guide

3-18

78-15755-01

Page 64
Image 64
Cisco Systems manual Cisco Global Site Selector 4490 Hardware Installation Guide