Cisco Systems 5500

7-18

Cisco MGC Software Release 7 Operations, Maintenance, and Troubleshooting Guide

OL-0542-06

Chapter7 Maintaining the Cisco Catalyst 5500 Multiswitch Router

Replacing Hardware Components

Contents

Main CHAPT ER Maintaining the Cisco Catalyst 5500 Multiswitch Router Checking Equipment Status Cisco Catalyst 5500 LEDs Supervisor Engine Module LEDs Ethernet Switching Module (10BaseT 24 Port) LEDs 10/100 Mbps Fast Ethernet Switching Module (10/100BaseTX 12 Port) LEDs Route Switch Module LEDs Using the Command Line Interface to Check Status Replacing Hardware Components Avoiding Problems When Inserting and Removing Modules Tools Required Removing the Supervisor Engine Replacing the Supervisor Engine Using Flash Memory (PCMCIA) Cards (Supervisor Engine III) Removing and Replacing the Power Supply Removing an AC-Input Power Supply Installing an AC-Input Power Supply Removing a DC-Input Power Supply 7-12 Cisco MGC Software Release 7 Operations, Maintenance, and Troubleshooting Guide OL-0542-06 Chapter7 Maintaining the Cisco Catalyst 5500 Multiswitch Router Replacing Hardware Components o 28649 Installing a DC-Input Power Supply Page Removing and Replacing the Chassis Fan Assembly Removing the Fan Assembly 7-16 Cisco MGC Software Release 7 Operations, Maintenance, and Troubleshooting Guide OL-0542-06 Chapter7 Maintaining the Cisco Catalyst 5500 Multiswitch Router Replacing Hardware Components Installing the Fan Assembly Perform the following steps to install the new fan assembly: assembly up slightly, aligning the top and bottom guides. SYSTEM STATUS SYSTEM STATUS Checking the Installation