Cisco Systems 6509-NEB, OSR-7609 manual Installing the 3000 W AC-Input Power Supply

Replacing the Power Supply

Installing the 3000 W AC-Input Power Supply

Caution Use both hands to install and remove power supplies. Each Catalyst 6500 series AC-input power supply weighs between 22 pounds (9.9 kg) and 28 pounds (12.6 kg).

To install the 3000 W AC-input power supply, follow these steps:

Step 1 Ensure that the system (earth) ground connection has been made. For ground connection instructions, refer to the installation guide for your hardware platform.

Step 2 Verify that the power switch is in the Off (0) position on the power supply you are installing. (See Figure 7.)

Figure 7 3000 Watt AC-Input Power Supply Front Panel

AC power

connection

Cable

etention
device
		110-120V - 15A
		200-240V - 15A
		60/50HZ
		T			L	I
				L
		S	A		N
	N				U
Power	I			R
	O
switch
						INPUT FAN		OUTPUT
						OK	OK	FAIL

OUTPUT 42V /17A
42V	/17A
OK

105069

External power

Captive installation Status LEDs (3) connector cover screw

Step 3 Grasp the power supply handle with one hand. Place your other hand underneath the power supply, as shown in Figure 8. Slide the power supply into the power supply bay. Make sure that the power supply is fully seated in the bay.

Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note

12 78-16162-02