23
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
OL-10362-06
Supported Hardware
WS-X6724-SFP 2.23 A@42 V 24-port Gigabit Ethernet SFP
•CEF720 with WS-X6700-CFC (adds 0.75 A@42 V)
•dCEF720 with WS-F6700-DFC3BXL (adds 3.30 A@42 V)
•dCEF720 with WS-F6700-DFC3B (adds 3.00 A@42 V)
•Supports egress multicast replication
•QoS architecture:
–
With DFC3: 2q8t/1p3q8t
–
With CFC : 1q8t/1p3q8t
•Number of ports: 24
Number of port groups: 2
Port ranges per port group: 1–12, 13–24
Supported only with Supervisor Engine 720 12.2(33)SRA
Note
•WS-X6724-SFP requires one of the following:
–
WS-F6700-DFC3BXL (3.30 A@42 V)
–
WS-F6700-DFC3B (3.00 A@42 V)
–
WS-X6700-CFC (0.75 A@42 V)
•WS-X6724-SFP ships with WS-X6700-CFC installed unless ordered with WS-F6700-DFC3BXL or WS-F6700-DFC3B.
•WS-X6724-SFP is supported in the WS-C6503-E chassis.
•WS-X6724-SFP is not supported in the WS-C6503 and CISCO7603 chassis.
•On WS-X6724-SFP ports, STP BPDUs are not exempt from Traffic Storm Co ntrol suppression. Do not configure Traffic
Storm Control on STP-pr otected WS-X6724-SFP ports that interconnect network devices.
•See the “Small Form-Factor Pluggable Modules (SFPs)” section on page 26.
WS-X6816-GBIC 3.84 A@42 V 16-port Gigabit Ethernet GBIC
•dCEF256
•QoS port architecture (Rx/Tx): 1p1q4t/1p2q2t
Number of ports: 16
Number of port groups: 2
Port ranges per port group: 1–8, 9–16
With Supervisor Engine 720 12.2(33)SRA
Note
•WS-X6816-GBIC requires one of these for use with Supervisor Engine 720:
–
WS-F6K-DFC3BXL (adds 1.47 A@42 V)
–
WS-F6K-DFC3B (adds 1.67 A@42 V)
•In a 13-slot chassis, WS-X6816-GBIC is supported only in slots 9 through13 and does not power up in other slots.
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version