18
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
OL-10362-06
Supported Hardware
10-Gigabit Ethernet Switching Modules
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
WS-X6704-10GE 6.28 A@42 V 4-port 10-Gigabit Ethernet XENPAK
•CEF720 with WS-X6700-CFC (adds 0.75 A@42 V)
•dCEF720 with WS-F6700-DFC3BXL (adds 3.30 A@42 V)
•dCEF720 with WS-F6700-DFC3B (adds 3.00 A@42 V)
•Supports egress multicast replication
•QoS port architecture (Rx/Tx):
–
With DFC3: 8q8t/1p7q8t
–
With CFC : 1q8t/1p7q8t
•Number of ports: 4
Number of port groups: 4
Port ranges per port group: 1 port in each group
Supported only with Supervisor Engine 720 12.2(33)SRA
Note
•WS-X6704-10GE requires one of the following:
–
WS-F6700-DFC3BXL (3.30A@42V)
–
WS-F6700-DFC3B (3.00 A@42 V)
–
WS-X6700-CFC (0.75 A@42 V)
•WS-X6704-10GE ships with WS-X6700-CFC installed unless ordered with WS-F6700-DFC3BXL or
WS-F6700-DFC3B.
•WS-X6704-10GE is supported in the WS-C6503-E chassis.
•WS-X6704-10GE is not supported in the WS-C6503 and CISCO7603 chassis.
•In a 13-slot chassis, WS-X6704-10GE is supported only in slots 9 through 13 and does not power up in other slots.
•On WS-X6704-10GE ports, Spanning Tree Protocol (STP) bridge protocol data units (BPDUs) are not exempt from Traffic
Storm Control suppression. Do not configure Traffic Storm Control on STP-protected WS-X6704-10GE ports that
interconnect network devices.