Cisco Systems UCSSP6C220E, UCUCSEZC220M3S 3-30, 19 Replacing the Mezzanine Card, PCIe1, PCIe2

Chapter 3 Maintaining the Server

Installing or Replacing Server Components

e.Loosen the single captive thumbscrew that secures the mezzanine card to the motherboard standoff.

f.Pull the mezzanine card toward the server front about one inch to disengage it from its motherboard socket, and then remove the card from the chassis.

Step 2 Install a new mezzanine card:

a.Set the new mezzanine card in place on the motherboard, aligning its connector with the motherboard socket. Also align the captive thumbscrew with the standoff on the motherboard.

b.Push on both ends of the mezzanine card evenly to engage the card’s connector with the socket on the motherboard.

c.Tighten the single captive thumbscrew that secures the mezzanine card to the motherboard standoff.

d.Reconnect cables to the mezzanine card. See RAID Controller Cabling, page C-19for more information.

e.Replace the top cover.

f.Replace the server in the rack, replace cables, and then power on the server by pressing the Power button.

g.If this was a replacement card, continue with Restoring RAID Configuration After Replacing a RAID Controller, page C-23.

Figure 3-19 Replacing the Mezzanine Card

	1
	SAS1
	SAS2
FAN1	SAS1	SAS2
		PCIe1
FAN2	CPU1
		PCIe2
FAN3
		PSU2
FAN4	CPU2
FAN5
		PSU1

2

331711

1

Captive thumbscrew

2

Mezzanine card connector on motherboard (partially visible under PCI riser 2)

	Cisco UCS C220 Server Installation and Service Guide
3-30	OL-25760-01