Cisco Systems C3850NM410G Wireless Quality of Service Wireless Targets

© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 15 of 70
class-map CALL-SIG
match dscp cs3
class-map CRITICAL-DATA
match dscp af21 af22 af23
class-map VIDEO-STREAM
match dscp af31 af32 af33
class-map Scavenger-Q
match dscp cs1
After traffic is identified using DSCP, policy bases can be applied on classifications.
policy-map 2P6Q3T
class VOICEQ
priority level 1
class VIDEOQ
priority level 2
class NETWORK-MGMT
bandwidth remaining percent 10
class CALL-SIG
bandwidth remaining percent 10
class CRITICAL-DATA
bandwidth remaining percent 10
class VIDEO-STREAM
bandwidth remaining percent 10
class SCAVENGER
bandwidth remaining percent 1
class class-default
bandwidth remaining percent 25
The egress policy can be applied to the port or L3 interface similar to the ingress policy.
Wireless Quality of Service
Wireless Targets
In wireless QoS, there are two terms: upstream and downstream. Upstream means ingressing from the access
point and egressing from the wired network. Downstream means ingressing from the wired network and egressing
out to the access point. The following table summarizes the QoS marking/policing and queuing capabilities on each
type of target interface: access point, radio, SSID, and client.
In wireless targets, QoS policies can be applied on multiple levels. Each of these targets is discussed in the
following sections.