© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 60 of 70
Comparing the preceding output with the one in the initial client join, notice that the access point name changes to
the switch IP address to where the clients roamed (switch/wireless management IP address of MC1 in this case),
and the protocol state becomes “Mobile.”
MA1#sh wcdb data all
Total Number of Wireless Clients = 2
Clients Waiting to Join = 0
Local Clients = 0
Anchor Clients = 2
Foreign Clients = 0
MTE Clients = 0
Mac Address VlanId IP Address Src If Auth Mob
-------------- ------ --------------- ------------------ -------- -------
b065.bdbf.77a3 500 20.1.1.53 0x00D03BC000000002 RUN ANCHOR
b065.bdb0.a1ad 500 20.1.1.52 0x00D03BC000000002 RUN ANCHOR
Relevant outputs displaying the client detail on the anchor switch, MA1, as in the following:
MA1#sh wireless client mac b065.bdbf.77a3 detail
Client MAC Address : b065.bdbf.77a3
Client Username : blackbird
AP MAC Address : 0000.0000.0000
AP Name: 20.1.3.2
Client State : Associated
Wireless LAN Id : 1
Wireless LAN Name: Predator
Protocol : Mobile
Channel :
IPv4 Address : 20.1.1.53
Mobility State : Anchor
Mobility Foreign IP Address : 20.1.3.2
Interface : WIRELESS_VLAN
VLAN : 500
Access VLAN : 500