© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 57 of 70
Initial client join on MA1, as seen in CLI on the switch, where it shows the client MAC address, to which access
point it is connected, and the WLAN and 11n on 5GHz:
MA1#show wcdb database all
Total Number of Wireless Clients = 2
Clients Waiting to Join = 0
Local Clients = 2
Anchor Clients = 0
Foreign Clients = 0
MTE Clients = 0
Mac Address VlanId IP Address Src If Auth Mob
-------------- ------ --------------- ------------------ -------- -------
b065.bdbf.77a3 500 20.1.1.53 0x00DC7DC000000005 RUN LOCAL
b065.bdb0.a1ad 500 20.1.1.52 0x00DC7DC000000005 RUN LOCAL
MA1#show wireless client mac b065.bdbf.77a3 detail
Client MAC Address : b065.bdbf.77a3
Client Username : blackbird
AP MAC Address : 203a.076f.abe0
AP Name: 3602I_G1/0/1_66BC
Client State : Associated
Wireless LAN Id : 1
Wireless LAN Name: Predator
Protocol : 802.11n - 5 GHz
Channel : 157
IPv4 Address : 20.1.1.53
Mobility State : Local
EAP Type : PEAP
Interface : WIRELESS_VLAN
VLAN : 500
Access VLAN : 500
MA1#show mac address dynamic | include Ca1
Vlan MAC Address Type Ports
----- ----------- ------- -----
500 b065.bdb0.a1ad DYNAMIC Ca1
500 b065.bdbf.77a3 DYNAMIC Ca1
where “Ca1” is the access point CAPWAP data tunnel and it shows that the client MAC addresses are seen behind
the Ca1 interface.
As mentioned earlier that the mobility controller has visibility of all clients across all mobility agents, the following is
the client visibility CLI on the mobility controller for clients local on the mobility agent.