Cisco Systems CISCO1841-HSEC/K9-RF manual Closing the Chassis, Applying the AIM Label, 11-11

Chapter 11 Installing and Upgrading Internal Modules in Cisco 1800 Series Routers (Modular)

Modules Internal to the Cisco 1841 Router

Figure 11-10 Correctly Installed AIM

58696

Applying the AIM Label

The AIM label for the chassis might be in the AIM mounting kit, or it might be attached to the label on the AIM card. To apply the chassis label, follow these steps:

Step 1 If the chassis label is attached to the label on the AIM card, carefully tear off the chassis label at the perforation. If the chassis label is in the AIM mounting kit, remove the label from the kit bag.

Step 2 Peel the chassis label from its backing.

Step 3 If there is a suitable space, apply the chassis label to the back of the chassis. If no suitable space is available on the back of the chassis, apply the label to the top cover at the back edge. The label must be visible with the chassis installed.

Note Do not apply the AIM label for the chassis to a blank cover plate; to any removable network

module or interface card; or over any holes, screws, chassis vents, or existing labels.

Closing the Chassis

To close the chassis, follow these steps:

Step 1 Rotate the cover down onto the chassis. Slide the cover back onto the bottom of the chassis. See Figure 11-11.

Step 2	Push firmly to close.
Step 3	Turn the router upside-down.
	Cisco 1800 Series Routers (Modular) Hardware Installation Guide
OL-5876-03		11-11