Cisco Systems CISCO1841-HSEC/K9-RF Verifying the Hardware Configuration, Initial Configuration

Chapter 7 Power-Up Procedures for Cisco 1800 Series Routers (Modular)

Verifying the Hardware Configuration

Figure 7-1 LEDs on the Front Panel of the Cisco 1861 Integrated Services Router

	SYS	1
	POE
	VM
	WLAN
4		230870
3
2
1

1	SYS	Solid green	Online
2	POE	Solid green	Connected
3	VM	Solid green	Online
4	WLAN	Blinking green	Connected

Verifying the Hardware Configuration

Verify the router hardware configuration by using the following commands:

•show version—Displays the system hardware version, the installed software version, the names and sources of configuration files, the boot images, and the amount of installed DRAM and flash memory.

•show diag—Lists and displays diagnostic information about the installed controllers and interface processors. Typical examples are interface cards (VWICs, WICs, HWICs), and advanced integration modules (AIMs).

Initial Configuration of the Router

This section covers the following topics:

•Initial Configuration, page 7-5

•Verifying the Initial Configuration, page 7-6

•Completing the Configuration, page 7-6

Initial Configuration

You can configure your router by using one of the following tools:

Cisco 1800 Series Routers (Modular) Hardware Installation Guide

OL-5876-03 7-5