Cisco Systems CISCO1841-HSEC/K9-RF 11-9, 8 Plastic Standoff Orientation, AIM end, Locking end

Chapter 11 Installing and Upgrading Internal Modules in Cisco 1800 Series Routers (Modular)

Modules Internal to the Cisco 1841 Router

Figure 11-8 Plastic Standoff Orientation

AIM end

Locking end

82620

Step 4 Insert the connector on the AIM into the AIM connector on the system board. See Figure 11-9.

Note Be sure to press firmly on the AIM until the board seats onto the connector. The plastic standoff must snap into the hole in the AIM board. See Figure 11-9.

Step 5 Insert the screws from the accessory kit through the AIM into the metal standoffs. See Figure 11-9. Carefully tighten the screws with a Phillips screwdriver.

Cisco 1800 Series Routers (Modular) Hardware Installation Guide

OL-5876-03 11-9