Cisco Systems CISCO1841-HSEC/K9-RF manual Verifying the LED Indicators on the 1841 Router

Chapter 7 Power-Up Procedures for Cisco 1800 Series Routers (Modular)

Verifying the LED Indicators on the 1841 Router

.

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

Note If the rommon 1> prompt appears, your system has booted in ROM monitor mode. For information about the ROM monitor and the bootstrap program, see the “Using the ROM Monitor” section in Cisco 1800 Series Router Software Configuration.

Verifying the LED Indicators on the 1841 Router

Verify that you have correctly installed the router by checking the LEDs shown in Table 7-1.

Table 7-1	LED Indicators
LED		Color	Status
SYS PWR		Green	Router has successfully booted up and the software is functional. Slow,
			steady blinking when system is booting or in the ROM monitor.
SYS ACT		Green	Blinking when packets are transmitted or received on any WAN or LAN
			interface, or when monitoring system activity.
CF		Blinking	Flash memory is busy. Do not remove the CompactFlash memory card
		green	when this light is on.

Verifying the LED Indicators on the 1861 Integrated Services Router

Verify that you have correctly installed the router by checking the LEDs shown in Figure 7-1.

Cisco 1800 Series Routers (Modular) Hardware Installation Guide

7-4 OL-5876-03