Cisco Systems CISCO1841-HSEC/K9-RF manual Rack-Mounting the Cisco 1861 Integrated Services Router

Chapter 4 Chassis Installation Procedures for Cisco 1800 Series Routers (Modular)

Setting Up the Chassis

Step 3 Align the mounting-screw holes with a wall stud, or use wall anchors.

a.For attaching to a wall stud, use two #10 wood screws (round- or pan-head) with #10 washers, or two #10 washer-head screws. The screws must be long enough to penetrate at least 3/4 inch (20 mm) into supporting wood or into a metal wall stud.

b.For hollow-wall mounting, the wall must be at least 1/2 in. (12.7 mm) thick. Use two wall anchors with washers. Wall anchors and washers must be a size suitable for the wall to which they are mounted.

Figure 4-7shows the wall-mount bracket for the power supply and the mounting-screw holes on the back of the bracket.

Figure 4-7 Wall-Mount Bracket for Power Supply

242658

Step 4 Position the power supply in the bracket.

a.Orient the front and back of the power supply vertically.

b.Position the end nearest the power cable at the top.

Rack-Mounting the Cisco 1861 Integrated Services Router

To attach the brackets to the Cisco 1861 Integrated Services Router, perform the following steps.

Caution Do not overtorque the screws. The recommended torque is 6 to 8 in-lb (0.7 to 0.9 N-m).

Step 1 Attach the mounting brackets to the Cisco 1861 Integrated Services Router chassis as shown in Figure 4-8, using the screws provided. Use four screws on each side. Use a number 2 Phillips screwdriver to install the bracket screws on both sides of the chassis.

Figure 4-8 Attaching Rack-Mount Brackets to the Cisco 1861 Integrated Services Router

1
VIC
4FXS/DID
3	2
	1	0	IN USE
00

242684

Cisco 1800 Series Routers (Modular) Hardware Installation Guide

OL-5876-03 4-9